- Output: Continuous current 40A, short-time current 55A (less than 10 seconds);
- Power input 2-6 LiPo or 5-18 NiMH / NiCd battery pack;
- BEC output: 3A (switch mode power supply regulator-switch mode)
- Maximum speed: 2 Poles 210 000 r / min, 6 poles 70 000 rev / min, 12-pole motor 35 000 rev / min;
- Dimensions: 55mm (length) * 28mm (W) * 12mm (H);
- Weight: 35g (including heat sink);
- Accessories: gold-plated motor connectors and heat shrink tubing three (optional);
A security function on power: power, regardless of the throttle stick in any position the motor will not start immediately, to avoid causing personal injury;
2 Throttle Calibration: Throttle range to adapt to different remote control differences, improve throttle response linearity;
3 Programmable Items:
- Brake Settings: brake enabled / brake;
- Battery type: Li-xx (Li-battery) / Ni-xx (nickel-cadmium or nickel metal hydride);
- Low Voltage Protection Mode: reduce power on / off output;
- Low Voltage Protection Threshold: low / medium / high;
- Start mode: normal / soft / super-soft and start;
- Timing: low / medium / high;
- Restore the factory default values;
4 comprehensive protection functions:
- Undervoltage Protection: set by the user through the process, when the battery voltage is below the protection threshold, ESC automatically reduce the output power;
- Overvoltage Protection: input voltage exceeds the input range are not allowed to start, automatic protection, also issued a rapid "beep beep" alarm sound;
- Overheat Protection: Built-in temperature sensing circuit, MOS tube temperature automatic shutdown when the power transfer;
- The remote control signal loss protection: remote control signal to reduce power loss of 1 second, then 2 seconds of non-remote control signal is output off;
- The power input uses high-capacity low-impedance electrolytic capacitors, which greatly improved anti-jamming capability;
- output power MOSFET with a separate heat sink, effectively reducing the device temperature, high current ability to work to improve the system;
- Single-chip control;
- microcontroller chips using an independent regulator, to avoid interference caused by power supply BEC load changes, to improve the stability of single-chip work;
- provide gold-plated motor connectors and heat shrink tubing DPM, easy to install (Note: This is optional equipment);
